Hi
I am in the process of looking for a new kitchen & would be very grateful for any advice on where to buy.
I have heard different stories about different suppliers. Ie bad reviews about B&Q. Really expensive fitting etc.
Also would you suggest a local fitter or go with Ikea, B&q...
I will give it a go and see what happens. Is the water inlet easy to remove ?
Im a bit worried about a leak especially with electrics. Is it on the right ? :roll:
Thanks very much ! Top bloke.
Below is a link to the engine.
http://www.showerdoc.com/GNS-20101080-8-5kW-Replacement-Shower-Engine
If you move the cursor over the engine it enlarges.
Is it the green/yellow wire, and the two black ones in the middle I remove ?
Thanks again.
Thanks for your advice.
Im not stupid but im not great at DIY.
So obviously I would turn the water and electric off.
Take cover off, take the engine off. But before taking the engine off do I have to disconnet 2 wires and piping ?
Can you tell me what will be going in to the new engine...
Hi
I was told by Gainsborough that is the water pressure drops below 1 bar then a switch inside the shower shuts down the heat element ?
Im sure my shower is in someway connected to my boiler as I had a new glow worm put in 18 months ago in my loft and they guy said he would run the water...
Hi
My shower stopped producing hot water when the water pressure dropped below 1 bar. I have since increased the water pressure to 2 bar. (As well as the boiler wouldnt work so not hot water from rads and taps, now it is all fine).
My shower though still produces cold water. I have a...
Thanks.
According to the Gainsborough website if the water pressure drops below 1 bar, which is did then :
Is there sufficient water pressure? The minimum working pressure required is approximately 1 bar at 8 litres per minute. If you have enough pressure the small white plunger between the...
Hi
yesterday my boiler wouldnt work, so not hot water etc plus my electric shower wouldnt produce hot water.
I checked the boiler and found the pressure was below 1 bar. I have fixed that problem, boiler working fine now.
BUT my Gainsborough 8.5 SCL is not producing hot water just cold. I...
I havent seen it.
I rang Gainsborough and ordered a new PRD but I have to wait til that turns up. Can I pop the ball back in then ? It may well be down the plug hole now or could it still be in there just loose ?