Thanks for the reply.
I ended up getting a Marcrist CK650 from Screwfix.
It still chipped the porcelain slightly but the cuts will be siliconed anyway.
Hi
I need a 115mm 22mm diamter diamond angle grinder blade to cut some 10mm thick poreclain tiles.
Looking online shows numerous from £3 upwards. I have tried a normal masonry blade in my angle grinder and it makes a horrible mess of chipping the tiles.
Please could anyone recommend a...
Hi,
I am tiling around my bath.
Just noticed that the tile place gave me rapid set adhesive (powdered, as tiles are 60 x 30cm).
Question is, I am going to have to tile the top row on all 3 sides before I can add the tile trim (to make sure the miters are nice and tight). Being rapid...
Hi
In the process of doing our bathroom and made the mistake of painting (with bathroom emulsion) where we are to tile.
I have done the tape test and put some masking tape on the paint, left it on overnight and it's pulled the paint off when removing the tape.
So, I need to remove the...
Hi
I am replacing a conventional radiator in a bathroom with a chrome towel radiator. The previous radiator DID have an earthing strap connected. I have been told (not by an electrician) that earth bonding on rads is not required if your CU is RCD protected. Our CU does have an rcd switch...
Hi,
I am wanting to fit a small towel rail in my bathroom. The bottom of the towel rail will be approx 12" above the value covers on the photo below.
I am wanting to extend the CH pipes vertical behind the wall and then for them to come out of the wall just under the towel radiator to be...
Thanks for the reply. I don't think it is the drum causing the noise. If I spin the drum it's quiet and smooth.
The noise is coming from the bottom right where the filter is. I think it's the re-circulation pump that may have some grit stuck in there causing this noise.