I'm having a wee bit of an issue with this.......I had to fit a replacement motor (new, genuine item) to the B9B.
When replacing the pump (complete with a new drive dog) if the 3 allen screws are any more than finger tight, the pump goes out of alignment slightly, just enough to give a tight spot when the fan is spun.
I'm not so dim as to tighten the screws unevenly or too much, but this time I've had to leave them a little slacker than I would really like.....
I'd be delighted to hear any comments and advice!
John
When replacing the pump (complete with a new drive dog) if the 3 allen screws are any more than finger tight, the pump goes out of alignment slightly, just enough to give a tight spot when the fan is spun.
I'm not so dim as to tighten the screws unevenly or too much, but this time I've had to leave them a little slacker than I would really like.....
I'd be delighted to hear any comments and advice!
John