What is the gap around my garage floor for?

Joined
30 Aug 2015
Messages
7
Reaction score
0
Country
United Kingdom
Hello,

I have a garage/barn on my new property, approx. 100 years old, single brick walls and timber and tiled pitched roof.

There is a gap around three walls (not the doors end), it measures 2 inches wide, and about 1 foot deep. The floor is concrete and it has a single layer of bricks edging it, which seem to go right down to the bottom of the gap. The concrete has some metal ties (?) joining the concrete to the walls (see 3rd pic)

I want to use the garage as a workshop and want to try and keep it as warm as possible, but this gap seems like a source of dampness.

I would like to fill this gap with something (expandable foam/concrete even - any ideas) but I first want to know what this gap is for, any ideas?

Thanks!
 

Attachments

  • IMG_0510.JPG
    IMG_0510.JPG
    92.6 KB · Views: 178
  • IMG_0511.JPG
    IMG_0511.JPG
    82.4 KB · Views: 182
  • IMG_0512.JPG
    IMG_0512.JPG
    119.3 KB · Views: 184
  • IMG_0513.JPG
    IMG_0513.JPG
    57.4 KB · Views: 207
  • IMG_0514.JPG
    IMG_0514.JPG
    54.6 KB · Views: 211
Sponsored Links
Looks like it was a cavity wall and someone has removed the inner wall to get a few more inches of space in the garage.

If you can accept the loss of about 12 inches width ( 6 inches each side ) then rebuild the inner wall. This will reduce heat loss considerably.
 
Thanks, I don't think I will go to the expense or trouble of re-building the inner wall, but was thinking of insulation board/wooden battens and plasterboard or plywood sheets - would it make sense to fill the gap with something?

Thanks!
 
Sponsored Links
Looking at how clean the tops of the bricks are, is it possible that it never had an inner leaf - but whoever built it had in mind converting it later, so started with the cavity up to floor level.
 
I might however make sense to put something across the top to stop "stuff" falling down the gap.
It will be "rather annoying" to drop something and have it go plink down the bottom of the cavity.
 
Because there is no need, and will serve no purpose. That's how cavity walls are.
 
Thanks,but left as it is, won't the dampness come up the gap and be transferred into the room?
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top