extra siren and strobe connections on accenta panel

jonnyfirepants · 14 Feb 2016

hi, I have an alarm system fitted (accenta panel/ pyronix deltabell), and have added an extra zone for the garage. the zone side is up and running but want to connect an extra siren and strobe on the garage itself. I have 2cores available for each, but am unsure of connections from the usual str+/-, T A D B. would these be able to be added on without overloading the circuit? is is not a large system, 3 pir's + 3 door contacts.
pictures of items I want to add included, thanks

sparkymarka · 14 Feb 2016

Depends on the current draw on the above devices ... I would fit either another deltabell,or a Texecom bell set to low current mode or scb

jonnyfirepants · 14 Feb 2016

thanks for the reply, but with trying to keep the cost down i was looking at using these, plus I think another bellbox on the garage is a little over the top for what I need. is there a way of using these items in scb mode? or would the siren alone or a similar type without the strobe be do-able?

sparkymarka · 14 Feb 2016

Try siren on its own ... Probably 350 ma or 500ma if it's an old one

jonnyfirepants · 14 Feb 2016

cheers, will have a look at its rating tomorrow, basically if it run it for a minute or two and it doesn't take the bell fuse out it should be fine?, but what would the connections be? ta

sparkymarka · 14 Feb 2016

D +
B -

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

extra siren and strobe connections on accenta panel

jonnyfirepants

sparkymarka

jonnyfirepants

sparkymarka

jonnyfirepants

sparkymarka

DIYnot Local

Similar threads