Search results

I have just purchased a new Bosch built under freezer GUD15A50GB. It is designed for a decor panel. I'm fitting it in place of an old Bosch built under fridge complete with decor panel. The problem I have is the decor panel fitting are completely different, but I also can't see how to fit the...

Ok thank you. Great help.

Yes Thanks. I have a bit of a leak on the valve joints as well needs attending too at the same time. So really have to drain it anyway. I've turned it all off at the moment. Just really need to know if I can heat the hot water whilst its off. With the immersion heater? I won't use the boiler.

I am going to drain my indirect heating system to remove a radiator for decorating. Can I still leave my hotwater running on the boiler. Or should I turn it off as well. Thanks.

Thanks Jo. But it's not just where the filler is. It's pretty general all over. I didn't water down the first coat because it had previously been painted and it was only a couple of spots that needed filling.

Hi. Just prepared a room for painting. Removed all the loose flaky paint, then filled in as necessary, sanded down the entire wall areas, washed with sugar soap then clean water. When I painted with a crown Matt emulsion the paint immediately started to blister with air bubbles some of which...

Getting an electric shock off the drum. When I put a meter on the drum to earth its showing 110VAC. Any ideas? Other than stop using it which I have done.

To be quite honest I didn't know or notice this before I had the system replaced. What I'm trying to find out is, is it acceptable in a pumped system to have a radiator that is now not in the pumped system as such? Because to be quite honest if its acceptable, and the installer told me it...

Had my gravity heating system replaced with a pumped system. The gravity system had an expansion radiator in the bathroom adjacent to the airing cupboard/hot water tank. The expansion radiator has been re-piped into the pumped system, (I was told as per requirements). Now the the system is...

I have some good quality hardwood windows about 20 years old which I am just rubbing down and recoating. However some of the Espagnolette Multi Point Window Locks need replacing and I am having trouble finding exact replacements or anything similar. They are as follows: U-Rail type, with...

Thanks Paul, I'll look them up. regards Rodney

Does anyone still produce glazed edge wall tiles? Or Bullnosed tiles? For doing the window ledges and corners.

Thanks guys, I had thought as much. Came across this trawling the internet what do you think www.hometeck-uk-ltd.co.uk? The unit has been in place for around 14 years and is well supported, can't match the tiles and have no spares as I used them when fitting a new shower screen last year...

Is there anyway of repairing ceramic shower trays? I have just noticed mine has a long thin crack in it. Its a major job to replace it as all the drainage piping is in the ceiling space and means removing part of the plasterboarding etc. Any advice would be appreciated.

Sorry guys, I made a mess of uploading the photos. Foolishly I followed the instuctions at the top of the page for "upload pictures" should have known there was a catch somewhere, i.e. they don't upload to the forum post your on when you upload. But at least someone found them, thanks. I've...

Are there any suitable replacements for RO80 eyeball spots that have the same size diameter ceiling cutouts, i.e.140mm? For use in a kitchen ceiling, with bedroom above, 120mm deep void space. Is this a notifiable change?

Please take a look at the photos I have posted. Its at the meeting point of a door frame and a hardwood floor. These small piles of dust keep appearing. Hoover it up and a week later its started to build up again. No sign of any creatures but then you don't always see them? Any suggestions as...