Search results

Kerbside front spring dropped and pierced the tyre. What do you think this would cost to repair (roughly). Any advice would be appreciated also on how to carry out this repair myself.

Trying to compile a list of usual technospeak b/s for the bosses for the main attributes/skills of a gas engineer for a forthcoming job evaluation. Ive got a few written down, working to standards, health and safety etc but im trying to get as many as possible, any suggestions would be appreciated.

toiling with this one,no power on display, 230v on x1-1 and x1-2 at 5 pin connector, both fuses i can see are ok, not sure how this boiler actually operates, where does the pcb get power from, is it the pcb interface x7, and do you still get parts for this boiler.

cheers, will give it a go

air bag light on, how do i reset without taking to garage

cheers guys, will try screwfix

where can i purchase a tool for taking off old pump valves, dont like using grips on these and im sure there are proper fixed 52mm spanner like tools that fit these, cheers

Boiler sitting idle when heating/dhw called for. Pilot light led alight but pilot not lit. Getting 47 v at common on air pressure switch. Linked out air pressure switch , common and nc ,and boiler fires and runs ok. Went back today with switch but exactly the same thing happening. Any ideas...

Diagnosed faulty dhw microswitch and the front seal part which caused a leak into the switch in the first place. Anybody know the part no,s for these parts and price, does seal come seperate or part of service kit, cheers guys

cheers,will check under seat

service and airbag lights illuminated. Are there any checks i can do before i take it to a garage and is this a common problem on these cars.

can an intermittent 08 fault be caused by a partially blocked venturi instead of the obvious burner stat, i have heard some fellow engineers discuss this at work

what way does the dimples in the ch diaphragm point, upward toward the microswitch i presume. Also, the small impulse pipe that meets the ch flow switch at the back, can that be cleaned out with a small piece of wire or do you have to take it out completely, not good access to sides of boiler...

Trvs possibly chattering on new rads due to wrong direction

what length of flue run is there, ie, does it immediately bend and go outside or has an extension kit been used

i would phone him and ask him if he removed fan/ flue hood to remove venturis, if he didnt get him back for to fix it for free

cheers for your input guys, will put any similar questions in cc next time

even the sixth edition is quite vague on this and only says id if entering property but does not mention if not entering property, think next time i ll make it at risk to be on safe side.

yeah, prob should have posted it in there, i suppose it could be at risk depending on weather conditions, mind you a spillage test is reliant on weather conditions on an open flue appliance and potentially could fail from one day to the next also

Found an ideal classic ff350 boiler only 200mm horizontally away from an openable window. In the absence of man inst i went with the usual 300mm so i did a risk assessment with my flue analyser and found no spillage or pocs entering property. I then made this ntcs on the certificate, do you...