Search results

  1. jordan1

    Vokera transmitter and reciever encoding

    I just stuck the batteries in my transmitter and sat it next to the reciever which was still flashing green and red so I held in the reciever button for 5 seconds to start encoding. How long should this procedure take ?
  2. jordan1

    New Triton electric heater overheating

    I just installed a new Triton Cara electric shower. It was just a straight swap for the old electric shower. I installed and commisioned as per manufacturers instructions and the shower works correctly up untill the temperature knob goes past number 5, 1-5 work fine but when I turn to 6 it...
  3. jordan1

    Fitting a new bath with storage water supply

    I have a shower tray to take out and a bath to fit in its place, the house's water supply is all tank fed with low pressure. I could easily tee into the basin connections for it but im not sure if i should as they are 15mm or if I need to make new connections altogether? Would it be ok to tee...
  4. jordan1

    fitting shower tray

    i am going to be fitting a shower tray with legs onto a concrete floor but am not sure how to fix it. Do i just sit it in its position, pipe it and seal it round the edge and then the tiles will hold it in place?
  5. jordan1

    no hot water from taps

    Hi, when i woke up today there was no water coming from any of the taps, i disconnected the first fitting from the boiler and there was still no water there. It is and old potterton combi, I am a plumber myself but am not gas safe registered although i have done alot of heating work but not...
  6. jordan1

    solder

    I was doing a job and ran out of solder, luckily i have a plumbers merchants across from where i stay but to my disbelief they wanted over £8 for it ( 1 roll ), i couldnt believe it and i didnt take it. To be honest I have always got my solder for free from work so dnt know how much they are but...
  7. jordan1

    flow and return

    i have a combi and my living room radiator has 2 lockshields, i think the flow abd return are mixed up, will this effect the system or should it still work ok. What happened was the pipe was blocked so i repiped it but when i fired it up i noticed the flow was going into the left hand side of...
  8. jordan1

    leaking basin

    I just fitted a basin and cannot get it to hold water, i silliconed the grating and left it for 24 hrs as i always do, it was sealed, when i filled the basin the water held but when i pull the plug the water pours out from underneath inbetween the plastic nut and the underside of the basin, help...
  9. jordan1

    how to remove a jammed immersion heater?

    immersion is jammed in hot water cylinder, cant get it out?????
  10. jordan1

    gate valve snapped in closed position

    hello guys, i am doing a job for a m8 and when i turned off the gatevalve on the hot water supply at the cwsc it snapped in the closed position, i am going to insert a rubber bung to the outlet inside the tank but as there will be no pressure to hold the bung in place because the water is not on...
Back
Top