Search results

Hi Everyone I poured a new concrete slab for my garage floor yesterday and even though it's as flat as a pancake in terms of levels the finish is not what I wanted for painting. I can see two products on the market for final finish, Level IT Top and Ardex 301. To make matters worse I have a...

Must have been done by the same company that did the new B&Q site! Complete rubbish!

I'm thinking of something like this, This one is only 200 * 150, so at least twice the size. There must be something on the market. Checked, thank you.

Hello Guys! I've got a really small loft entrance, no hatch currently in place, just a hole going into the loft. It's tiny, about 300*450. Just an access hatch really for the extractor fan etc. I'm after an off the shelf loft hatch that I can screw into the ceiling which once opened will...

Good Morning guys, I had BC over this morning to inspect external drains before backfill. I have a number of roddable gullies on the system. I was told by email from BC that air test wasn't required on external work but upon arrival requested air test on external. This has been left for a...

I was asked to do a soakaway test intitially, however it would literally put be on my neighbors wall as It's a very small garden. Thank you for your advice. Best Regards

Hello Guys. I was wondering if you could see anything wrong with these proposed drain layouts. Thank you in advance :) PS, I know I should ask BC, I've not managed to get the time off work to get them round. I've emailed my BCO officer but he's on annual leave. I think it should be...

Hello Guys, I need to open up the the whole on already fitted tile for a waste pipe. I think the best course of action would be a small grinding wheel that would go on the end of the drill, kind of like what you would see on a Dremmal. I've searched toolstation & screwfix without any...

Thank you for coming back to me, what sort of pre-treatment would they require? J

Hello Guys, I've come up with an idea, wickes are currently doing beach tops @ about £90. Is it beyond the realms of possibility to stain on of these tops to a dark walnut colorr to match the existing walnut worktops I've already got?

Thank you for those links, I'll take a look :)

Hello guys, I'm after an off the shelf walnut laminate worktop in East Sussex, near Eastbourne / Bexhill preferably. Can anyone recommend anywhere that's not wickes / B&Q etc Best Regards J

haha I used a mutli tool, worked a treat.

Just the job, Thank you :)

Unfortunately not, it's set in concrete :(

Hiya guys, I need to cut 110 waste pipe further back than what is accessible from the external part of the pipe. Is there anyway to cut 110mm from inside? Thanks in advance J

i thought about that, but it's not really a standard installation and I don't think I've explained it very well. I actually want to put the dallmer into the 110mm pipe, a bit of a custom installation :) J

Hello guys, I have a Dallmer vertical drain to fit a showerlay board. The drain has to fit into a 110mm waste pipe coming vertically out the floor. The vertical 110mm goes into a 110mm p trap so I don't actually need the trap of the dallmer. My question is, does anyone know where I...

:)

This wall is all over the shop. It's some plasterboard from where doors have been blocked up, some render, there is render missing and there is a whole load of pipe work thats gotta go through it. This wall is 9m long J