Search results

Zipper Your memory is spot on. The valve just lifts out after removing the small cover held in by the one screw. It will take all of 5 mins to replace the valve. Happily with your help my machine is now working correctly and at little or no cost. Finally Zipper. once again many many...

Last night after finding the none return valve I tried cleaning round the seat of the valve with an old tooth brush. I did this from the front of the machine with pump removed. I could not see any dirt. but when I tested the machine with the left side cover off so I could see the matrix, when...

I have checked the pump and all appear OK, The fill pipe was clear of any obstructions. The pipe that runs from the pump to the matrix was also clear. The matrix is clear. including the valve at the top. I have also checked the fill out let pipe that is also clear. What I...

Thanks again zipper for your continued help. I have tried several times to reset the machine when I have been testing all the wash cycles over the past week. When I press the reset buttons the cycle always stops the wash cycle it is on. Does the same thing it does at the end of a full cycle...

zipper Thanks for your help so far. Where do I find the pressure switch on this machine? If it turns out to be the PCB board I assume you refer to the larger of the 2 with the read out? Is it possible to test the items to confirm a failure of one or both? once again many thanks...

TYPE S9G1B E/NR SGS45E02GB/45 FD8408 004791

My bosch dishwasher runs through its wash cycle fine and cleans its load well but when time gets to 0 time remaining the pumps appear to keep running and the heater is still on, water is pumped out. The machine will continue like this until the power is switched off. The the machine will restart...