Search results

hi, it was updated about 6 months before issues started

I will get back to you when home. It's a 10.5kw shower, I know that much off hand

switch same as this http://www.toolstation.com/shop/p64900?table=no can't post pics just now as at work

yes turn the shower off at the shower, not the 20amp switch which is outside the bathroom

it turns the power on to the shower then press the on/off button on the shower to turn that on

it is a cold water fed electrical shower

its a 20amp switch, I'm thinking I need to change to a higher one rather than a loose connection as the wires were all still in the connections fine but the plastic inside showed signs of melting and soot

Hi, for the second time in a year the shower power switch outside my bathroom has overheated and melted inside causing the shower to trip out, what could be causing this? Both time its seems to have happened in the morning when all 4 in the house have been going in for showers one after the other

Thanks John, that's what i will do

Hi, so the french cleats on my kitchen units are not going to match up with the studs on my kitchen wall. I am going to cut out the plasterboard and replace with ply and screw the units on to this. However it is just hardboard backing on the units, will screws through this in to the ply hold?

Hi, the paint on exterior of my house is flaking and almost powdery like as in photos. I had same issue just over a year ago and rubbed it back and painted the bare render, but it has happened again. How to i go about getting rid of this problem?

the wee covers dont seem to come off the handle

the radiator has been in for near on two years and no problems, valves have been closed since about April and just opened this week

how do i take head off?

Hi, the valves either side of my bathroom radiator are leaking at the bit where turn the valve to open and close. When have them both totally closed no water comes out, but when turn the valve it is leaking at the handle bit, am i going to need a new radiator?

Hi, the 90deg waste pipe for my toilet is it wrong angle for my new toilet. Can i cut this before the bend and replace with a flexable fitting? This new fitting looks like would slip inside old pipe with rubber fins, this sound like a goer?

How long should you leave it between having room skimmed and tiling on to the walls, is it the same rule as for painting or do you need leave it longer?