Search results

Mainly for internal 15mm. I use a rothenberger pipe cutter the silver snap on type and it slightly bends over the inside of the pipe that to me looks like it needs deburring Thanks

Here is the tap. It is leaking from the spout to body - as you can see. I may just try replacing the o rings in there. The spout is also wobbly.

Thanks I have the box set after replacing my own kitchen sink but that plastic bit on my tap was brass with the separate long nut that gos on to clamp a horseshoe under. This one looks to be just a plastic shaft but I can not see what it is doing.

First off what am I looking at here. Do I see some sort of back nut amongst all that rust. And if that is how the tap is fixed to the sink then what is the purpose of the plastic part with the slotted end. I am trying to find a photo example that is not rusted so I can see what I am up against...

Looks like JB weld then - thanks everyone

There is something very wrong with you two. I get the impression you two are in an iron lung and have nothing to do all day but try an start arguments.

There is no way Trump could be a dictator - he dances on stage to village people. - Gets my vote.

Great. The sides inside the old fireplace space can be dot and dab plasterboard and the back section stood off with 2x2 battens, same as the base. To fit any buleray etc make sure that the hole will be wide enough. The vent at the front need not be a nasty plastic thing - look for something...

The problem is that did not work out well for sadam husain did it. He kept saying he had this or that capability when he didn't but blair used that as an excuse to attack knowing full well that he never had any WMD.

In my opinion the TV is far too high for comfortable viewing. If the heating in the room is ok I would not bother with the new fire which will be encroaching into the room with the added section. I say put skirting across the front with a vent there. the red bit is the fireplace hole the sides...

I get good lasting results by adding fibreglass strands to the wet mix of 3 to 1 sharp sand but I sometimes sieve the sharp sand as I find that there can be some bigger stones in there which makes it tricky for the thinner joins. I also use gaffer tape to mask off each side of the slab joint -...

This is notch's problem - he believes everything the Gov and BBC tell him, covid/vax/climate. And everything else is a conspiracy in his mind.

I have been looking for this and it seems that it might no longer be available. Looking for the 2 tube set up like this. None of the main shopping sources sell it and from a quick google there are a few other shops that all seem to be out of stock. I can find plastic padding super steel which...

Finally! What I have been saying all along

I wasn't using h8nsight tho was I - it was at the time. And I only had my government on my tv every day and it was my government giving me orders. Any way - see you later

Anyway the sun is out and i have things to do - so a tip for those asking the same question over and over- I have given you my honest full answer and any more of the same questions will just be replied with a cut and paste.

I told you. The more they ramped up the fear the more I distrusted what they were telling me - the more censorship the less trust I had in the official line. All of their nudge units/ social behaviour experts, focus groups to think up wording did not work on me. the army unit monitoring the...

I gave you my answer, I don't know what you want me to say. Just because I did not believe B J it doesn't therefore mean that I then went on the internet looking for something else to believe in

Just because I did not believe B johnson it doesn't therefore mean that I believed anyone else instead.

I think its because any threads on the subject always get shut down and locked before they have run their course. Some one seems to always get the thread locked. I wonder who it could be. :unsure: :rolleyes: