Search results

Hi All, I'm renovating the kitchen and just clearing down before 1st fix. I'm planning on putting amtico down so getting the floor right is important. I've lifted the old carpet and vinyl tiles and having a tap around realised that parts (2 sqm) of the floor, particularly around the edges...

Grey side for everything if it's knauf... brown side's no good for anything

I know this is super old, but I've got the same issue. I found these http://www.designadeckshop.com/pack-of-2-stainless-steel-post-feetbases-100mm-or-150mm-416-p.asp which, although expensive, should do the job...

Think I've managed to track some down... company called 'Barretts'. Phew!

Hi All, I'm trying to build a pretty hefty log store (approx 9m long x 4m wide x 2.5-3m high). The idea was to use ex telegraph poles for 6 uprights then add rafters, purlins and box section for roof then feather-edge the back and sides, leaving the front open. The problem that i'm having is...

Although with the logic that I was hoping for the CH wouldn't pump if the store was below, say 60 degs...

Thanks Norcon - that's actually a valid point thinking about it...

Does anyone know of a control pack that includes the room thermostat and 7-day timer but can also relay cylinder thermostats and apply defined logic to output?

Store is a 350l Gledhill Torrent RE with some additional stove tappings

Ah, ok, I may not have been clear enough here... The reason that this is not a waste is that there is not a boiler in the system. The heat sources are 2 woodburning stoves and a solar array. The 2 stoves are on thermosyphons with thermostatic flue controls, but obviously I want the thermal...

Hi, I'm trying to design the heating control for my thermal store but I'm struggling to find anything that will do what I need even though it should be quite simple. The logic I'd like to apply is: - If top cylinder temp is over 85 degrees then turn on heating (irrespective of room therm's...