my printer used to work fine on my bt hub 5 , nothing has changed but it now wont connect , printer works fine with usb lead , tried re pairing wps but wont connect , downloaded canon software and when I get to the select access point it shows my network but the connect button is greyed out so...
5 should be white/blue , 2 should be blue/white and 3 should be orange/white , either the cable is faulty or your socket is faulty or what you have plugged into the extension socket is faulty . Take the extension socket of the end of the cable and plug the frontplate back onto the master and...
I had one of these and it did exactly the same , it will be a fault in the reciever not switching the voltage to the boiler but as you say the light comes on saying it is receiving the signal , probably a faulty relay or similar in the reciever , bin it and buy a reputable one thats what I had...
I dont think it will fitas the screw centres are different to mine , mine is the same as http://www.double-glazing-parts-repairs.co.uk/35-92-Replacement-Door-Lock-Gearbox , gu 35/92 e19786
Hi all , I have a gu 35/92 lock and I am trying to replace it with a split spindle lock , does anyone know of a lock that fits or will I have to buy the whole locking mechanism ???
If it comes out as a damage report as dangerous , it may just get made safe , ie taken down and not put back up , then you would have to raise a fault on your line
I haven't asked a question for a long time , now I know why I gave up on this site . what is the point of a d I y forum if all you get is abuse and unhelpful answers .
It works fine on dhw but from cold on heating it usually does flame failure , from cold dhw works fine , I know it will be suggested low gas rate but surely that would affect the dhw as well , any pointers great full received .
I have a upvc door that the latch is operated by both handles , I want it so that the latch can only be opened from inside on the handle and would need the key from outside , at the moment the key does not operate the latch just the handles . Do I need a complete new lock unit or can it be setup...
The boiler and all pipework rads etc are 5 years old , the boiler is needing to be pressureised three times a day , there are no leaks on any rads , valves etc . The expansion pipe is not dripping at all . It seems to lose pressure when the hot tap is being run which would point me at the dhw...
I spoke to Xpelair tech help this morning and she was very unhelpful , she insisted that without a wire connected to the SL terminal then it would not work as a humidistat fan . I told her I would now wire it up including a switch. I wired it up as per instructions and guess what it is exactly...
The unit has an led that comes on if power is supplied to the switched live terminal via a pullcord , this has not been connected to anything and the led is off ,this fan is brand new and I think it must just be a faulty unit .
Mode can't be set can it ? It is auto humidity and switched override ?? I have tried it with the humidity dial (blue one ) fully anticlockwise - most sensitive , mid position and fully clockwise - least sensitive .