Search results

ffs Grow up, simply making it clearer, go find your dummy. Go do some reading and learn something

?

As far as I am aware, a qualified ACS gas engineer who holds MET 1 can move a gas meter up to 2 meters (Not the ECV) with permission of the gas supplier

Thank you for your kind responses, really appreciated

Apologies, the gas meter has been installed for many years

If a gas meter and ECV are installed above a rear exit door, does this contravene Gas regulations and should it be moved due to the height and issues with reaching the ECV in the event of an emergency. Basically, you would need a chair to get to the ECV to turn off the gas.

I can't find any reference to this any place Would it be installed the normal heights of a kitchen wall unit 410 mm from base unit and 75 mm away from cooker? Thank you in advance

Much appreciated many thanks, which document is this from please?

When installing 10 mm plastic Polyfit pipework under floors to radiators on a new combi system, should the 10 mm pipe be insulated? If so, is it a manufacturer's requirement or building regulations? Many thanks in advance.

The following regulation: Building Regulation requirements: Zone Controls The Building Regulations require that all new systems in non-open plan domestic dwellings with a total floor area > 150m2 should have at least two separate heating zones, with one zone covering the ‘living area’. Heating...

Was wondering what the average costs are to install a full heating system in a 3-bedroom house, including 5 rads gas boiler and plastic pipe. Also, looking for a recommended Gas Safe Registered engineer on here who can provide a quote to install the heating system, based in Greater Manchester...

Hi all, I have read a regulation some place that if the combined KW of gas boilers is over a certain amount, you must install an emergency cut-off switch near the door. I know it's over 300Kw but cannot remember the exact KW figure or where I have seen the regulation. Any wise owl on here...

That's the problem, there is none fitted, so basically, it would be impossible to find out who installed the cylinder if multiple registering organisations are used?

So basically, they can self certify but must register the newly installed cylinder with one of the above governing bodies you mention? If you don't have a copy of the compliance certification, how could I find out who the cylinder is registered with and get a copy? Thanks again

Do Unvented Hot Water Cylinders, once installed, need to be registered as fitted and if so who with? Thanks in advance OOPS just found this and to clarify; does this mean the installer of the unvented cylinder must notify Gas Safe Register they have installed a New Unvented Cylinder on an old...

If a property is converted to all-electric and the gas meter is no longer needed, is there a charge to have the gas meter removed? Been told if the gas meter is capped off and left in there will be a standard charge payable, but if I want the meter removed and capped off, there is a charge of...

Not sure if this is the right place to post the above, but has anyone completed the application form mentioned, and if so are there any completed examples to give guidance anyplace? Thanks in advance?

Could any kind soul suggest a wall-mounted, water-fed wall heater manufacturer? I'm trying to source a wall-mounted water heater fed from a Combi boiler to install within a very small kitchen; too small for a radiator or a plinth heater. Many thanks in advance ?????????

Many thanks all, really appreciate your help.

Morning all, I'm looking for some software that will calculate if the main incoming fuse within the property is large enough to take a full load of all the appliances within the property such as shower, Hob, microwave kettle etc. Would be ideal to be able to select an appliance within the...