Search results

Don't forget about space factor as well.

There's nothing in any of the menus to enable the "old" way with favourites. Sky changed it when they updated the EPG for HD users and I must admit it is a pita when it goes back to the previous channel when you press the blue button. What I've started to do is press channel up before pressing...

If it is the security settings that are to high, you could try setting up a DMZ (De-Militiarised Zone) on your router. Give your PS3 a fixed IP address under network settings, make sure it's not going to interfere with other connections though. For example if your router uses 192.168.1.0 to...

Klockner Moellers 'T' range go to a maximum of 315A clicky

The phaonmneal pweor of the hmuan mnid, aoccdrnig to a rscheearch at Cmabrigde Uinervtisy, it dseno't mtaetr in waht oerdr the ltteres in a wrod are, the olny iproamtnt tihng is taht the frsit and lsat ltteer be in the rghit pclae. The rset can be a taotl mses and you can sitll raed it whotuit a...

We put them onto the coil winder and run it backwards, then just look at the counter when it's all been run off. :lol:

Try here Amazing what you can find with the search button :wink: :D

Thanks for the info, regarding the optimiser. I do have the original blanking plate, so that's not a problem. I presume there'll be a terminal block on the pcb somewhere for the programmable room stat connections?

Thanks for the varied replies guys. To clarify a few things, we wanted to replace our Radiation Fuelsaver boiler so we obtained three quotes, one from BG, and two from local companies, obviously the BG quote was the most expensive at £2,800, the other two quotes being £2,300 and £2,280. All...

Recently we have had our old boiler, f/e tanks and the hw cylinder removed, and replaced with a WB 30cdi combi, using a corgi registered local firm. The boiler works as well as expected, but some installation problems that occurred had me wondering if we have any recourse to compensation for...

:oops: :oops: :oops: That'll teach me not to make assumptions from peoples location.

RF, You must be a Rhinos fan of a proper sport. If a rugby player stays down, then you know he's injured. Not like these over paid namby pamby premiership footballers.

Use your postcode, then click on the BT ADSL button. It should tell you the straight line distance at the bottom of the page.

There still is clicky>> Loads of other info as well.

Maintenance/Installation sparky in a paper mill

Loads here

If it's a cast iron gate, wire it up to an electrified fence controller, :shock: Mythbusters tried it and Adam Savage has never been the same since.

Did the replacement lamp have an in-built ignitor? It's possible that the light fitting doesn't have an ignitor, it's required to provide a high startup voltage for the lamp to strike. Look for the letter I in a triangle somewhere on the lamp body, if there's none there then it's the wrong lamp.

Hi Graham Have worked with some of the earlier Mitsubishis and found them easy to install & commission. IMO I would install the inverter into a separate control panel with the Stop/Start controls on the front along with a speed control potentiometer. Ensure ventilation to the panel as...

The maximum input current (for the 1.5Kw) of 17.4A is too much for it to be taken from a normal 13A socket outlet. Normally this size inverter would be fed from a 20A radial. A 3ph 230V 1.5Kw motor draws at max load approx 6A per phase, as you only have single phase input this is why it...