Search results

We are looking for advice for removing a lincrusta frieze in a Victorian house safely so it can be put back again once building work is complete. The wall it is on is being removed and a RSJ going in behind where the lincrusta is currently, We have removed the picture rail and thinking a flat...

I've got a relatively new UFH system on an existing S Plan with system boiler & unvented cylinder. The UFH has never worked properly which we think is due to air in the system, the main symptom being the Wilo pump will flash red/green and stop pumping water around the loops. Despite flushing...

Thanks, that was indeed the issue. I couldn’t remember how the live & S/W live were connected to COM, L1 & L2 in the Wago as it’s now inaccessible. Joined the COM (blacks) in the back of the intermediate switch & connected brown to L1 and grey to L2 which sorted it.

Yet another post about 3 way light switch wiring! I've read quite a few posts but I have an odd one which still can't make head nor tail of despite checking & double checking wiring diagrams. I have 2 x 2 way switches at each end with intermediate in the middle. With the current wiring the...

They were originally according to the design spec. The pic shows far right and far left fully open as I was just testing what would happen with a couple of circuits running rather than all of them (still the rads were heating up)

Got a bit of an issue with a newly installed UFH system on an existing S Plan with system boiler & unvented cylinder. The UFH has been added to a new first floor of the property which includes rads in the rooms without UFH. A branch has been taken off the 28mm flow and return from the boiler to...

Huge amount of work to remove, re-plaster the inevitable loose bits around the frame, refit and redecorate. They are the original Victorian deep frames & architrave.

As part of a project to upgrade some old Victorian doors to 20min fire doors (agreement with building control), I need to decrease the gap between door and frame on several of them and them use Intumescent coating on the internal side & edges of the doors. Then finally fit intumescent strips...

I've got an old cast iron panel radiator that I've recently had stripped and repainted. On piping up it has a weeping leak from the bleed screw at the top. Taking the screw out and cleaning up I could see the screw thread has a notch in it and the hole that it screws into also has notches in...

I did yes, although it is not up and running yet as I've not finished the renovation project. Having never installed one before I found it easy to install once I'd read all the instructions and watched the skill builder youtube videos a few times. The components sent are good quality and the...

We've just laid a wet room shower tray former (30mm) thick direct to joists as specified. Unfortunately the floor around it isn't quite level which is a suspended floor again with UFH and overlaid in 6mm plywood (glued & screwed). To bring the floor level with the shower tray (which is...

Yes 12v at the bell point along with the door push. Shelly 1 sounds like a good option, the blurb says it can be used to detect a door bell push. I just need to find a wiring diagram to find out how to do it :)

I've got a victorian style 12v wired door bell in my house but looking to modify it so it could notify the various Echo Dots I have around the house. A routine would be straightforward enough, but need a relay or similar that would get triggered when the door bell is pressed. Doing a search...