hi,
just about to install new bath, the waste is the pop up type and the p trap is made from brass with a small length of brass pipe on the outlet. would you suggest just using a waste compression fitting to connect the outlet on the trap to the plastic waste pipe .
below is a link to a...
hi there,
the above boiler is on a y plan vented system, the problem is it will not fire up. the pump is spinning the 3 port is working ok.
i can hear the relay clicking on the pcb at start up but thats it no fan no spark any advice would be appreciated.
thanks
clarko
hello,
the problem is i have no c/h.when i call for heat the green neon light comes on , pump runs but no ignition, h/w is working fine.
any help would be grateful.
thanks
hello,
sime 80 combi, c/h works fine when a h/w demand is made boiler fires for 30 secs then cuts out, relights after about 30 secs flow rate has slowed down ,h/w temp has also dropped from what it was any help would be grateful.
thanks
hi,
i have a eljan jb40-50 warm air heater which functions correctly for c/h but the burner will not fire for h/w, the pilot is alight but nothing happens when a call for heat is selected . i have power to the gas valve , i suspect the solenoid is faulty. any help would be apprieciated...
fitz1 have you ever tried to burn plasterboard it is fireproof it can with stand a Rothenberger Surefire 2 s heat, i ve used plasterboard when my heat mat has yet again blown through
hello,
i am installing a 5" flue liner into a class 1 chimney, is there any reason why i cannot seal the base of the liner in the fireplace opening using plasterboard and dot n dab adhesive .
thanks
hi ,my friend has sime friendly combi it goes through the operating sequence ignites main burners for roughly 2 secs then cuts out could this be a defective gas valve or pcb fault.
many thanks