Search results

Probably is...Russia have been arresting lots of anti war protestors. She'd be old enough to remember the old soviet union under Stalin too.

Its technically ok just doesnt look too clever.

Without knowing what your mains pressure and flow rates are we can only give a subjective answer. The tap may only be providing 10lpm due to narrow flexis, flow regulators or filters within it. If im quoting for an unvented i always check dynamic pressure and flow rates at an unrestricted...

+1 More likely its dripping down onto the pan connector from the flush pipe above.

Its really not difficult to take out or refit on a logic and it shoudnt be brittle unless its been subject to some serious heat.

How the hell did they do that?! Was it cleaned with a hammer? OP it will be a condensate leak if its doing it mostly on CH.

Funnily enough ive had a call this week from a customer i fitted an 8000 for. Same problem...WB are going out to it under warranty

Because whatever it is, is being heated by the radiator causing the smell.

We're making a meal of this. Notch the joist and use a 90 elbow. Pulled bend wont give you the tight radius you need.

The hive receiver would clip onto that existing backplate.

Never used to use anything on compression joints but with the poor quality of fittings these days and the fact i started getting a lot of fittings weeping has meant i now use jet blue on the olives. Since then, all good again.

Quick question....why? (n)

Id take the surveyors observations with a pinch of salt re the ductwork as i dont imagine they know one end of a warm air unit from the other. Chances are the flue pipe will be single wall asbestos cement not the ducting with will be sheet metal

Only really useful if your cutting in a new isolation valve or replacing an old one.

This....because from what you've said OP, the guy hasnt a clue.

Entirely possible the boards popped...if you put the N from the old stat onto NO on the new one you've railed 230vac down the neutral

Take note of this

Copper is worth taking if you've got a decent amount. The rest isnt worth the fuel to get there.

Be fine....F3 can be left in indefinately, its not very strong.

I'll add on..if it smells chemically, it looks like cleaner has been left in. Fernox F5 looks that colour after a while