I have a Baxi Maxflow Combi WM giving some problems.
With it set to CH & HW on and the HW in need of warming the HW light lights, then the flame light lights and I can hear the burner starting.
However, after about a minute or less the burner goes out, as does the flame light and then doesn't relight. Also if the CH is set to come on this sometimes doesn't even fire up.
Switching off briefly, then switching on again gets it going. Sometimes I have to stand by the boiler and do this numerous times before it stays alight and starts heating the water.
The boiler is about 10-12 years old and this problem only started last winter. The beginning of this winter the boiler was all fine again, until I had a powercut and for some reason it has caused this problem to come back.
Could you help at all??
Thanks,
Joel
With it set to CH & HW on and the HW in need of warming the HW light lights, then the flame light lights and I can hear the burner starting.
However, after about a minute or less the burner goes out, as does the flame light and then doesn't relight. Also if the CH is set to come on this sometimes doesn't even fire up.
Switching off briefly, then switching on again gets it going. Sometimes I have to stand by the boiler and do this numerous times before it stays alight and starts heating the water.
The boiler is about 10-12 years old and this problem only started last winter. The beginning of this winter the boiler was all fine again, until I had a powercut and for some reason it has caused this problem to come back.
Could you help at all??
Thanks,
Joel