HELP Glowworm Micron 60ff wont work URGENT , PLEASE HELP

[julieanns]

whole estate electric went off this morning, electric just back on at 4 pm, but no heating, turned the control know to reset and tehn back on but still no heating

but both reset and burner lighs flashing fast, fires up for a few seconds but then goes off, i have since switched off by the wall as im scared of the thing

any help URGENTLY

 

[breadnbutter]

its possibly showing a phase supply fualt, its detected a short to earth or reverse polarity,or incorect voltage. becuase of the power cut.
turn off at fuse spure switch,and switch on again after 10 sec, reset at boiler control stat.
if that does not cure it,you need engineer to check your electrics to the boiler, its also possible its damaged the ciurcuit board

 

[CBF]

page 22 on should give you some indication of the flashing lights.

http://www.glow-worm.co.uk/stepone/data/downloads_sd/8d/00/00/micron-60ff.pdf

 

[julieanns]

hi, got it working gain, fine until it stopped today again, only reset light o showing solid green, in booklet as non-volatile lockout, ?

 

[breadnbutter]

volatile lock out = overheat.

you need gas safe engineer out.

possible the power cut has upset the pcb, and these pcbs,are a weak link to a good boiler. but needs confirming,by engineer,if it is pcb,change the thermister as well.