Kitchen Drawer closing problem

[LeeJC]

Kitchen Drawers ARgghhhhhhhhhh

I've got a 4 drawer unit, of which 2 drawers close perfectly but the other two i can only get to sit flush against the carcass on one side, they are sitting proud by about 5mm on the other side, which is noticeable, i push it down and it pops back out.

The drawers are sitting on the dual wheel standard type runners so has anyone come across this, who can tell me what i'm doing wrong before i smash it to pieces please.

Lee

 

[Jasonb]

Check that the draw box has been assembled squarely, If its out of square this will stop one side closing.

Also make sure the runners are the same distance from the front of the carcase on each side, ditto where the runners fit to the draw boxes.

Jason