Hello all my fist post on here starting to get back into DIY and have 3 project to do...
First is the front drive:
I'm putting up a 7' retaining wall in concrete block laid on the side 1500 in total.
2 questions
1. What mortar mix? 3 to 1?
2. I'm not laid manny block in my life and have seen all these block spacers out there but there not cheap so I was thinking of using 10mm ball bearings, would this work?
Thanks in advance.
First is the front drive:
I'm putting up a 7' retaining wall in concrete block laid on the side 1500 in total.
2 questions
1. What mortar mix? 3 to 1?
2. I'm not laid manny block in my life and have seen all these block spacers out there but there not cheap so I was thinking of using 10mm ball bearings, would this work?
Thanks in advance.
