Premier 48 KeyPad Zones

Discussion in 'Alarms, CCTV & Telephones' started by wcavanagh, 25 Jun 2011.

  1. wcavanagh

    Joined:
    14 May 2009
    Messages:
    413
    Thanks Received:
    3
    Location:
    Dundee
    Country:
    United Kingdom
    Sorry to bother you guys again.

    I notice the LCD Keypad has 2 zones on it, can someone confirm that I have understood this correct.

    The Prem 48 has zones 1 - 8, I can then map these two key board zones to 9 and 10, giving me Zones 1 - 10?

    Cheers,
    Will
     
  2. sparkymarka

    Joined:
    16 Feb 2011
    Messages:
    2,994
    Thanks Received:
    506
    Location:
    Sheffield
    Country:
    United Kingdom
    yes you can map to any zone number. 1-48 so if you where thinking of addind a zone expander on at a later date you could map to 17 +18 and so on
     
  3. wcavanagh

    Joined:
    14 May 2009
    Messages:
    413
    Thanks Received:
    3
    Location:
    Dundee
    Country:
    United Kingdom
    Thank you.

    Once final question, could I map one of these zones on the Keypad to and Entry/Exit zone?

    Just thinking I could connect the front door mag, and the hall way PIR to the keypad, then have one wire back from keypad to control box?

    I know it is usual to have zone 1 set as Entry/Exit, but is it possible?

    Cheers
    Will
     
  4. Alarm

    Joined:
    18 Oct 2010
    Messages:
    8,970
    Thanks Received:
    529
    Location:
    London
    Country:
    United Kingdom
    Yes to both.
     
  5. wcavanagh

    Joined:
    14 May 2009
    Messages:
    413
    Thanks Received:
    3
    Location:
    Dundee
    Country:
    United Kingdom
    Thank you again.

    Most helpful.

    Back to pulling wires in then.

    Cheers
     

Share This Page