1. We are pleased to announce the 'Home Automation' forum. Click here to get involved!

Semi pedestal and pop up waste to fit

Discussion in 'Plumbing and Central Heating' started by tel3563, 9 Dec 2007.

  1. tel3563

    Joined:
    15 Oct 2007
    Messages:
    6
    Thanks Received:
    0
    Country:
    United Kingdom
    Hi all, have bought basin with semi ped, no instructions just some fittings and some springs, can anyone explain in detail (simple detail :) ) how on earth i fit this to the basin, also the same applies to the pop up waste supplied with the mono hole tap, no instructions again, a diagram of both would be fantastic if possible :mrgreen: , I thank you in anticipation, t
     
  2. mmm80

    Joined:
    7 Dec 2007
    Messages:
    12
    Thanks Received:
    1
    Country:
    United Kingdom
    loop end of spring fits over basin hanger bollt, secured with nut and washer.
    unscrew plastic sleeve to stop.
    offer up semi ped, insert hook end of springs, tighten with plastic sleeves
     
  3. tel3563

    Joined:
    15 Oct 2007
    Messages:
    6
    Thanks Received:
    0
    Country:
    United Kingdom
    Thanks mmm but don't understand unscrew plastic sleeve to stop.
     
  4. mmm80

    Joined:
    7 Dec 2007
    Messages:
    12
    Thanks Received:
    1
    Country:
    United Kingdom
    do you have two springs with a loop and hook? well the plastic sleeve over spring, turn anticlockwise as far as you can
     
  5. tel3563

    Joined:
    15 Oct 2007
    Messages:
    6
    Thanks Received:
    0
    Country:
    United Kingdom
    Have the spring with hooks but don't seem to have a sleeve, where would this sleeve go on the spring and what would it look like
     

Share This Page