Texecom - Veritas R8 Alarm

Joined
4 Jun 2003
Messages
13
Reaction score
0
Country
United Kingdom
A quick question, which may be a dumb one, but this is the first alrm I have fitted.

When wiring up all the tamper alert wiring should I just run all eight/sixteen wires into the TAMP terminal pairs or is it better to run them first into a comnnector strip then to the TAMP terminal pairs?

Any advice would be most appreciated.

Regards

Mike D
 
Sponsored Links
globaltamper.jpg



If you take all the tamper wires straight to the tamper trminals, the tamper alert will only operate if the cover is removed from EVERY detector on the system.

Wiring in series, like it shows you in the installation manual will cause the tamper alert to operate correctly, (if ANY of the covers are removed.)
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top