We recently had to turn our water off and since we've turned it back on, only a tiny trickle is coming through the shower (Triton Opal 10.5). We've tried turning all the taps on & turning off the water, then turning the shower on and putting the water back on - it spurts a few times through the shower than goes back to the trickle and the low pressure light is on. What else can we do?
water not getting through to electric shower
- Thread starter jcal11
- Start date
Sponsored Links
inlet filters blocked.
isolate the water remove inlet pipe and you'll see a gauze filter git it a clean.
try running the mains when you remove pipe from shower to clean any muck out or it'll happen again.
isolate the water remove inlet pipe and you'll see a gauze filter git it a clean.
try running the mains when you remove pipe from shower to clean any muck out or it'll happen again.
check the valve is back on fully, then check any valves on shower pipe are fully open, then you might need to close the valve to the shower and disconnect the connection to see if there is any dirt blocking the inlet to the shower, if none of the above there must be a fault internally at the shower, possibly solenoid valve, (someone better experienced will advise on internal shower fault)
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
