Just trying to change the bearing on the motor on my riello G3B oil burner, im going to buy a bearing puller can anyone advise me on what type of bearing puller to get ie bearing puller size and type? hope that makes sense know noting about bearing pullers Thanks
What type of bearing puller
- Thread starter mickmassy
- Start date
Sponsored Links
If you scroll down you will see "Similar topics" the top one may help you a little.
Sponsored Links
Bearings are usually meant to have a interference fit of just a couple of thousandths parts of an inch, so No it should not slide on easy.
Having said that, I put a bearing on a washing machine and it did slide on.
Had to 'doctor it' with centre punch marks to make it a better fit.
But it should not be hard either, should be able to tap it into position using washer, piece of tube and hammer.
Having said that, I put a bearing on a washing machine and it did slide on.
Had to 'doctor it' with centre punch marks to make it a better fit.
But it should not be hard either, should be able to tap it into position using washer, piece of tube and hammer.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
