Rust from nail bleeding through paper

Joined
4 Nov 2013
Messages
377
Reaction score
11
Country
United Kingdom
Recently wallpapered our bedroom. There were a few areas where nails were left from the old picture rail. I touched them in with some solvent based gloss paint... Except I missed one.

Any there is a small area about 3mm dis where the rust has bleed. Shall I just seal it with the gloss?

Will this effect the emulsion paper much?
 
Sponsored Links
You mean the paper is emulsioned over?

If so, you can make a bit of a hole, knock the nail in a bit (if you can't remove it) and then use an oil based rust killer paint on the remains, fill, emulsion, etc.

Should have really removed these nails rather than just putting gloss paint over them, but you probably know that now!
 
Sorry... That post was terrible. I meant to say that the paper will be emulsioned later. At the moment it isn't.

So I could still open up a little hole or touch it in.

Yes... Always wise after the event :(
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top