Water meter connections
- Thread starter CAESAR32
- Start date
Sponsored Links
They are usually ½ or ¾ inch BSP.
Although they can be bigger.
Although they can be bigger.
Sponsored Links
Yes, but with service and drain off valves.
On most meters you can dispense with a connection. The male thread on the body of a 1/2" water meter is 3/4" BSP, 3/4" meters are 1" BSP and so on.
To fit a 1/2" meter to 15mm copper, dispense with the tails and fit a 15mm X 3/4" BSP female compression coupler.
Although, using this method makes replacing the meter a tad difficult.
Keeping the tails, use a 15mm X 1/2" female comp coupler.
To fit a 1/2" meter to 15mm copper, dispense with the tails and fit a 15mm X 3/4" BSP female compression coupler.
Although, using this method makes replacing the meter a tad difficult.
Keeping the tails, use a 15mm X 1/2" female comp coupler.
Service valve should be fitted after the meter to prevent the whole houses' pipe work draining through the open end. A drain off cock should be fitted after this service valve also.
Most common size, yes.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
