I have a lean to roof that runs away from the house at a pitch of circa 30 degrees.
I have installed 100mm Kingspan between the rafters using a friction fit. I need to install 35mm Kingspan under the rafters, an 'under drawer'. I intend to fully tape every single joint on this under drawer to ensure a Vapour control Layer.
Would anyone recommend taping up the gaps in between rafter insulation if i am fulling taping the under drawer insulation? There are minimal gaps with the between rafter insulation.
Thanks
I have installed 100mm Kingspan between the rafters using a friction fit. I need to install 35mm Kingspan under the rafters, an 'under drawer'. I intend to fully tape every single joint on this under drawer to ensure a Vapour control Layer.
Would anyone recommend taping up the gaps in between rafter insulation if i am fulling taping the under drawer insulation? There are minimal gaps with the between rafter insulation.
Thanks