box gutter

Joined
27 May 2007
Messages
185
Reaction score
0
Location
Essex
Country
United Kingdom
I'm having an extension/conservatory built it has a slate hipped roof which
butts upto the house hipped roof where they meet a box gutter is going to be built, the plans say the box gutter should be 300mm wide this seems excessive, the 2 roofs are not that big in fact quite small, does this sound right?. Also would alu be ok or is lead best?
 
Sponsored Links
Hi. The minimum width is 150 mm at smallest end (where is discharges)
However if it a box gutter please consider the tiles / slates will over lap into this gutter say 50 mm the 50 mm left would not allow pedestrian traffic for access or cleaning out. As for material, that depends on the skill knowledge of the fitters. With hard metals copper, zinc, alu, etc forming the drip end can be difficult when compared with lead, and i think it fair to say roofer are in general more akin to lead sheet than other metals. Good Luck
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top