adding inhibitor to combi boiler - Worcester Bosch

Joined
13 Oct 2010
Messages
1
Reaction score
0
Location
London
Country
United Kingdom
I am replacing a radiator for a higher btu rated one. But have noticed that the old water was showing signs of rust contamination. I want to add inhibitor to the system but not sure how to. I have a Worcester Bosch combi boiler. Any suggestions please.
 
Sponsored Links
...it will be easier if you remove the plug that the air vent needle screws into, or the plug on the other side. Then with a funnel and a bit of hose pour it in through the top. This is after you have fitted the rad to the valves, but before you have opened the valves to let it fill with water.

If you have drained the systemn, you can pour it down one of the pipes that the rad valves go onto (assuming they run downwards).
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top