concept system alarm, problem with keypad

ralfy · 2 Jan 2011

does anyone know what to do if the buttons on the keypad do not work? will turning the power off reset the system????

Help please

Denford1 · 3 Jan 2011

Remove mains and battery , power up mains first , use your code to silence ... 0123 if it doesnt work.

ralfy · 3 Jan 2011

Thank you for that but it didn't work, sorry to say if it helps the tamper light is on and now when we go into zones they light up, but the buttons still don't work. HELP please

Denford1 · 3 Jan 2011

You need to clear the tamper condition , close the panel lid first and press RESET see if it clears also check all detector lids.If not , put a link between the TAMPER connections , then the bell tamper (T + A).

Europlex · 3 Jan 2011

ralfy said:
....... but the buttons still don't work. HELP please

There's a blown fuse in the panel or more likely a duff battery, when was it last replaced, should be done at least every 5yrs, bet that's the problem.

ralfy · 8 Jan 2011

Sorry to sound thick but by panel you mean the bigger box away from the keypad? I'm not sure what's caused the tamper as all the indicators look fine. Could it be one of the smoke detectors as they've been playing up by going off in the cold!!!

Alarm · 8 Jan 2011

Are smokes connected to the alarm?

Is the noise outside?

Can you clarify what your issue is.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

concept system alarm, problem with keypad

ralfy

Denford1

ralfy

Denford1

Europlex

ralfy

Alarm

DIYnot Local

Similar threads