Risco Novaguard 4

Hi there again


What are the connections between a risco novag 4 and a accenta gen 4 panel.
Also how do you activate engineering mode so the bell box dosent go off every Time i open the lid to correct the wires?


Thanks Nathan

hi it does tell you the connections on page 4 of the info sheet but here goes from panel D OR 12V to 12v on bell box, A OR OV to ov on bell box,B OR BELL TRIG to S- on bell box, T OR TAMP to TMPR on bell box, STROBE- to strobe- on bell box and finally dont forget to link 0v in the BELLBOX to TMPF ( TAMPER FEED). hope this helps