Premier 24 and texecom speach dialer

Can someone give me advice on how to wire the texecom speech dialler into the premier 24 control panel.

I assume 0v 12v are power connection

Tamper wires into the control panel tamper circuit, which is not used (EOL wiring)

I am OK with the phone connection

But I am struggling with trigger inputs?

Do I wire them to corresponding trigger outputs on the control panel, if so do I wire all 4?


Safe Dave

You can wire them to the panel outputs and then programme according to page 55 of the installation manual

As above OP, and wire all 4 (if you require all 4).