Best way to finish edging

Hi all

I have two tile edges that need finishing - one is approx 17mm in depth and the other is approx 34mm.


17 mm


34 mm



I'm not sure if I should buy a corner trim for the 17mm edge like this one http://www.ebay.co.uk/itm/Corner-Wa...-Flexi-Angle-15mm-x-15mm-x-2-5m-/281290433941

and somehow stick this to the tile/wediboard edge... or if there is a T shaped tile trim that I could get in white to hide the cut marks on the existing tile end and allow me to cut and lay very thin tile strips on the other end. Not able to find such a product though

Not sure what to do with the larger edge - 34mm as I have a shower enclosure frame that butts right up so an angled trim won't work here.

Any clever ideas?

Lots of trims at: http://www.floorandwallsolutions.co.uk/

Normally you'd put the trim on before you tile (part goes under the tile or Wedi board in your case) so you may have to get creative or just use one of the corner protectors that stick on afterwards.

Are these floor or wall?

Hi there

These are wall shots. I'm thinking I can't get a standard tile trim as I'll have the perforated side showing which won't look right. So perhaps something like this is what I need:

http://www.ebay.co.uk/itm/White-UPV...im-15mm-x-15mm-x-5-metre-Length-/251468351593

Though to be honest I'd prefer something that is rigid but can't find anything in the size I need - 15mm x 15mm x 2.4m[/url]