Hi, hoping to get some help with this. have a glow worm 15 hxi bolier, controlled by a drayton dual channel programmer, when the programmer calls for hot water the boiler fires up and all is good. when the programmer calls for central heating, the boiler will not fire up. I have checked voltage in and out of programmer and all is ok, all the thermostatic is working and has voltage also. There are no fault codes showing just a temp. Checked wires for loose connections to boiler and exchanged circuit board, all still the same. Can anyone help with this ? worst boiler I ever brought lol !
Glow worm 15 hxi central heating not working
- Thread starter ditch69
- Start date
Sponsored Links
It's not the boiler mate...lol 
Check your motorised valve.
Check your motorised valve.
As above.
Either the synchron motors had it or the valve is stuck.
Either the synchron motors had it or the valve is stuck.
Hi thanks for the reply, il check it out now. is there an easy way to check the valve ? thanks again
Sponsored Links
Depends on the valve a picture or number would help.
Thanks again. its a mid position actuator valve
BGMVSP - 23
British gas NPC code 555312
Blue plastic cover over electrics
Thanks
BGMVSP - 23
British gas NPC code 555312
Blue plastic cover over electrics
Thanks
It's a drayton, try plumcentre for a new actuator head.
Didn't buy PCB acquired it lol, don't spend money unless I have to.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
