kitchen sink and appliances - help please!

stevenmc2 · 17 Aug 2006

ok so far so good. Would appreciate some further advice.

I need to connect flexi hoses from mixer tap to hot and cold water supply.

From both cold and hot water supply pipes I have stop-cocks in place. I now need to connect a length of pipe from both stop-cock ends to flexi hoses.

What do I need to do this? It would be simpler to use plastic rather than copper pipes.

ALSO- I need to fit supply to a washing machine (H & C) and dishwasher (H)

Would appreciate a step by step guide if possible

thanks again

chrishutt · 17 Aug 2006

Haven't you already posted this? It sounds very familiar.

stevenmc2 · 20 Aug 2006

yes! but I did'nt get a response!
____________________________
lynda, moderator

please note forum rule 1a, I have now removed your other post of the same question

fitz1 · 20 Aug 2006

take a little drawing of it to merchants and they will give you what you need.

Nige F · 20 Aug 2006

Thought C. went to dishwashers not H.............take the drawing in , mid-morning if poss. merchants are quietest then usually

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

kitchen sink and appliances - help please!

stevenmc2

chrishutt

stevenmc2

fitz1

Nige F

DIYnot Local

Similar threads