CO/CO2 ratio analysis

bster · 6 Oct 2006

Just received my Viper: gude to taking CO measurements and CO/CO2 ratios.

It states that different probes should be used depending on appliance type, when using FGA's. So does everyone here actually have 4 differing probes for their FGA's. Are they even available as accessories for all the FGA's on the market?

chrishutt · 6 Oct 2006

First I've heard of that. Why should different probes be required?

the plumbing miracle · 6 Oct 2006

also what you have to remember is using a performance tester on a cast iron heat exchanger isnt allowed,see an old acops training manual.

chrishutt · 6 Oct 2006

the plumbing moron said:
also what you have to remember is using a performance tester on a cast iron heat exchanger isnt allowed,

Bo11ocks.

bster · 6 Oct 2006

Over egged there!! - not 4 types but 2

angled probe for O/F fires and fluless water heaters, standard for all others.

chrishutt · 6 Oct 2006

Why would you need an angled probe for a flueless water heater?

Or for a gas fire, for that matter? Since when was flue gas analysis carried out on gas fires?

kevplumb · 6 Oct 2006

jeez chris i thought everybody knew you need an angled probe

chrishutt · 6 Oct 2006

Oh yeh, I forgot...

fitz1 · 6 Oct 2006

since someone paid a ****full of money out for one and thought im going to stick this everywhere.

doitall · 6 Oct 2006

fitz1 said:
since someone paid a s*****l of money out for one and thought im going to stick this everywhere.

Just don't stick it anywhere near this forum.

it will blow up

scatmanjohn · 7 Oct 2006

the plumbing miracle said:
also what you have to remember is using a performance tester on a cast iron heat exchanger isnt allowed,see an old acops training manual.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

CO/CO2 ratio analysis

Similar threads