potterton wiring diagrams

[maca]

poterton kingfisher 2,potterton ep30001,what wiring diagram is required

[baxpoti]

You could start here.

http://www.partsarena.com/baxi/

Catalog » Potterton » Boiler » Kingfisher 2 » Cf100 (GC No. 4160711) » Installation Instructions » Kingfisher II Control Systems, Pipework & wiring Guide

[abbeymead]

I have worked in this industy all my life and am very disapointed with Baxi potterton as thyey have been on watch dog 4 times for problems with there probucts shamefull from what use to be a good company Mr baxindale would turn in his grave
Just take the thing out and stay clear of baxi potterton

[baxpoti]

abbeymead wrote:

I have worked in this industy all my life and am very disapointed with Baxi potterton as thyey have been on watch dog 4 times for problems with there probucts shamefull from what use to be a good company Mr baxindale would turn in his grave Just take the thing out and stay clear of baxi potterton

4 times on Watchdog?
The name is spelt Baxendale
This post was for a wiring diagram for a Kingfisher!

If all you want to do is slag off boiler manufacturers, then start a new topic in general discussions!

[simond]

The Kingfisher II is not a bad boiler, if you discount the energy consumption.

I don't think advising to remove it because of a wiring fault should be taken seriously.

__________________
Simon

[DP]

A boiler I fitted some 5 years ago is locking out on flame failure randomly. Boiler is installed as an S plan with three zones, one of which is underfloor heating circuit installed by a construction company.

PCB was replaced sometime ago as there was no fan run to demand.

I know flame failure light would come on if ignition sequence did not complete. Any other causes that lights flame failure LED?

[baxpoti]

Your post subject states 'Baxi 105e'
This post is for a Kingfisher
Clarify which boiler you're posting about
You're probably better to start a new posting