Anybody able to help with connections between an Optima G3 panel and Texecom Odyssey 1E bellbos strobe.
The panel has the following;
T -ve tamper return
A -ve supply (0V)
D +ve supply(12V)
B -ve sounder trigger
and
+ strobe
- strobe
The bellbox has
A (12V) permanent +ve supply
B (Bell) -ve applied output to activate siren
C (tamp) -ve removed on tamper input
D (0V) permanent -ve supply
S (strb) -ve applied output to activate strobe.
I think:
T (on panel) goes to C (on bell box)
A (") goes to D (")
D (") goes to A (")
B (") goes to B (")
but I'm left with 2 strobe outputs from panel (+ and -) and 1 input ( -) on bell box.
Do I have these correct and how do I deal with the strobe?
help welcomed.
The panel has the following;
T -ve tamper return
A -ve supply (0V)
D +ve supply(12V)
B -ve sounder trigger
and
+ strobe
- strobe
The bellbox has
A (12V) permanent +ve supply
B (Bell) -ve applied output to activate siren
C (tamp) -ve removed on tamper input
D (0V) permanent -ve supply
S (strb) -ve applied output to activate strobe.
I think:
T (on panel) goes to C (on bell box)
A (") goes to D (")
D (") goes to A (")
B (") goes to B (")
but I'm left with 2 strobe outputs from panel (+ and -) and 1 input ( -) on bell box.
Do I have these correct and how do I deal with the strobe?
help welcomed.