Indesit W 102 stopping mid spin cycle. Flashing lights.

Hi,

Not sure if anyone would be able to help but perhaps someone might.

I have an Indesit W102 washer/dryer that was working fine for a month (not sure how many years old it is, rented property). Today put the towels to wash - two towels - mashine worked fine. Come the spin cycle, the drum spins 3-5 times, then something clicks and it stops immediatelly. Lights start flashing on the door on/off button and the stain removal button starts blinking oddly enough. Water drains fine so no problems there - cleaned the filter just in case, did not change anything.

Would appreciate any help! Thanks
Julia

might be gas valve, air pressure switch, fan, venturi, flame rectification device, divertor valve, giggle stick not inserting the tickling valve.

or you are in the wrong forum!!!!

Thank you! Gosh....dare not ask more

widl codes - light flashing from left to right are numbers 1-4

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light