Hose inlet quick question

Joined
14 Sep 2010
Messages
233
Reaction score
6
Location
Hertfordshire
Country
United Kingdom
Hi,

My washing machine is cold water inlet only. I then have a spare red lead (hot water I presume) which is lay around uncapped underneath the units.

Problem is I think it is leaking, is it because the screw above it's connector under the sink was a bit loose?

Thanks

Matt
 
Sponsored Links
it`ll be the valve letting by a bit :idea: . If it`s a normal washing machine valve on a copper pipe - you can remove it and fit a compression cap fitting in it`s place
 
it`ll be the valve letting by a bit :idea: . If it`s a normal washing machine valve on a copper pipe - you can remove it and fit a compression cap fitting in it`s place

either do as suggested here, or buy a 3/4" BSP cap and screw it onto the valve where the hose would have went, slightly easier for DIY'er
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top