Hi,
I am about to install a new system consisting of a Honeywell Optima G4 with built in keypad, and an ADE Reson8 Bellbox.
I have a question regarding the bellbox anti-tamper circuit.
The instructions with the bellbox tell me that when I enable the onboard battery link the sounder will output a tamper alarm, but it does not explain how I cancel that alarm.
Is it by simply fitting the bellbox cover, or do I also have to enter the user code into the control panel?
If so, it would follow that I should not connect the bellbox battery until the rest of the system is fully wired.
All help appreciated
pete 100.
I am about to install a new system consisting of a Honeywell Optima G4 with built in keypad, and an ADE Reson8 Bellbox.
I have a question regarding the bellbox anti-tamper circuit.
The instructions with the bellbox tell me that when I enable the onboard battery link the sounder will output a tamper alarm, but it does not explain how I cancel that alarm.
Is it by simply fitting the bellbox cover, or do I also have to enter the user code into the control panel?
If so, it would follow that I should not connect the bellbox battery until the rest of the system is fully wired.
All help appreciated
pete 100.