Catnic Lintel Installation - DPC & Drip Holes In Mortar?

Joined
15 Jul 2008
Messages
435
Reaction score
2
Country
United Kingdom
Is this the correct way to install a catnic lintel? Or are the DPC and 'drip holes' unnecessary? Anything else which should be included as part of a installation?

 
Sponsored Links
Erm....your (lower) image is showing bricks UNDER the whole lintel.

There are no bricks under the lintel only under the bearing ends.
 
Erm....your (lower) image is showing bricks UNDER the whole lintel.

There are no bricks under the lintel only under the bearing ends.

Haha! Yes, I got carried away with the copy and pasting :mrgreen:. Have now edited.
 
Sponsored Links
Weep holes go in the perps.
Should they be the entire height of the perp? And how common is it to use weep vents such as these?

file.php


That shows 'mortar thickness', so unsure how they are used in conjunction with a brick facade, or a rendered one for that matter as surely the rendered wall will have lots of small holes all over the place.
 
The type you show is fine, but there are also manufacturers who do the full height of the perp sizes as well, thats what my local merchants sell.

You sit them flush with the front of the brickwork - it may look a little odd if your looking hard, but it looks much nicer than a puddle in the cavity!

As for the holes in the render, same thing really, they end up pretty flush with the front of the render, and only in certain places, ie over windows and doors where your attention is much more drawn to the item under the lintel as opposed to the vents above!
 
Plastic weep holes are marketing gold.

How they have managed to persuade people to buy and use these is amazing.

Leaving a joint out is obviously not good enough. Never mind the fact that moisture seeps out around the outside of the plastic weep holes, between it and the brick or lintel it sits on!
 
Ok, I see that how you finish a weep hole is arguable, but good to know that one is recommended.

Should a weep hole be created at each far end of a lintel? Slightly inwards? Or should there be more than two (depending on the lintel length) and spaced 'x' mm apart?
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top