I am changing the position of the toilet in the bathroom. It will then be the other side of the waste stack into which it currently sinks via T connection.
It looks like the wastepipe is fixed above (due to the flashing on the roof) and below (due to bend), and I would therefore need to replace the whole stack and put a T connector facing the correct side.
Does anybody know of a way round this (are there any connectors that allow you to cut into the stack?) or any other ideas?
It looks like the wastepipe is fixed above (due to the flashing on the roof) and below (due to bend), and I would therefore need to replace the whole stack and put a T connector facing the correct side.
Does anybody know of a way round this (are there any connectors that allow you to cut into the stack?) or any other ideas?