Whirlpool dishwasher

Joined
20 May 2006
Messages
1
Reaction score
0
Location
Cardiff
Country
United Kingdom
I have a Whirlpool Dishwasher model no. DWF 413 Type 12137. 999929030538. It is approx 5yrs old & a fully intergrated unit.
that was constantly running (water just swishing around)for over 2 hrs! before we switched it off. This stopped it in the middle of its cycle. There was some dirty water in the bottom. I did notice that the internal filters were dirty, so I removed & cleaned them. Also cleaned the upper & lower spray arms. According to the manual, I should leave the door adjar for at least 1 min before continuing the cycle. I have done this but there is nothing happening. The lights are on to cycle. Is it blocked further in the drain pipe? if so how do I unblock this without disturbing the dishwasher?
 
Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top