1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice
D_Hailsham
Last Activity:
14 Jun 2021 at 12:50 PM
Joined:
18 Oct 2007
Messages:
10,587
Media:
185
Albums:
5
Thanks received:
1,342
Likes received:
153
Location:
Kent

Share This Page

D_Hailsham

from Kent

D_Hailsham was last seen:
14 Jun 2021 at 12:50 PM
    1. kevplumb
      kevplumb
      totally agree with what you where saying about heat loss it was a informative thread till the dick got in there
    2. debzo
      debzo
      Hi - hope you had a good break! I have ordered the 3-way mixer from Wita ( the manufacturers ) as I already have the original servo which apparently serves both the 3 and 4 way mixers. Once that arrives (from Germany) I will be altering the pipe-work to put the servo-mixer and UFH pump to serve both ground and 1st floor manifolds - which will each then have a 2-port zone valve to open and close as needed. My thinking is that the Delta should be able to be wired as per the drawing? So at the minute everything is still operated manually. I really appreciate all your thoughts and help on this - I now have a much better understanding of the system - even though I still have to resolve the wiring between the Delta and the junction box. Not sure what will go where, so am still trying to get my brain round that. If you have any further ideas, they would be more than welcome.
    3. seco services
      seco services
      your the man on wiring and programmers.
      i been on a post today randell 4033 about half way down the page.

      don't know if you had read it and gave it a wide birth.

      but the guy appears to have a gravity system pumped hw.
      but the bit i can't seam to get round is why his old programmer is using the hw off to feed the white wire on a zone valve.

      just wondered if you had an idea as it bugging me as to how its been wired and working if i've missed somesome

      thanks.
    4. seco services
      seco services
      mr hailsham you on here ?
    5. DEREK1959
      DEREK1959
      HELLO I HAVE JUST SIGNED IN NEVER USED B4 COULD DO WITH SOME HELP ON HERE HOW DO I ASK A QUESTION
    6. futureechos
      futureechos
      Thanks v much for your advice last week ref replacement for Glowworm Mastermind. New Siemens programmer fitted, works great.

      thanks again for sharing your knowledge.

      Mark
  • Loading...
  • Loading...
  • About

    Location:
    Kent
    Country:
    United Kingdom
  • Loading...
  • Loading...
  • Loading...