1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

ianmcd's Recent Activity

  1. ianmcd replied to the thread Water hammer from mid position valve.

    Post a pic of the pump and the valve, it does sound like the pump is the wrong way round

    17 Jan 2021 at 3:40 PM
  2. ianmcd replied to the thread Potterton Puma 80e cutting out after 1.15 minutes..

    You need to replace the wax capsual in the diverter valve, make sure you dont have any dripping taps or water leaks on a HW pipe...

    17 Jan 2021 at 3:32 PM
  3. ianmcd replied to the thread Hive to Alpha CB28.

    either way round for 1&3, doesnt matter it is just a switch and no need for an earth, run it and tether it if you want but it wont be...

    17 Jan 2021 at 3:18 PM
  4. ianmcd replied to the thread Vaillant ecofit pure keeps erroring.

    Do you not mean an automatic By-pass valve ? why would you fit a TRV ?

    17 Jan 2021 at 3:06 PM
  5. ianmcd replied to the thread Programmable Thermostat Advice.

    Yes Honeywell used to be good, but the market has been flooded by cheap rubbish, so everyone doing everything they can to lower prices,...

    17 Jan 2021 at 2:35 PM
  6. ianmcd replied to the thread Nest thermostat setup.

    Yes mate but how many times do punters forget to mention we used to have one but we dont use it any more, if they never had one then...

    17 Jan 2021 at 2:23 PM
  7. ianmcd replied to the thread Automatic air vent on Baxi duo tec.

    yep as simple as that

    17 Jan 2021 at 2:15 PM
  8. ianmcd replied to the thread Nest thermostat setup.

    Did you have a previous wirelss RF thermostat ?

    17 Jan 2021 at 2:13 PM
  9. ianmcd replied to the thread Hive to Alpha CB28.

    Why are you making everything so complicated ???? just rip the lot out 1&2 from the Alpha to 1&3 on the hive single channel and a L&N to...

    17 Jan 2021 at 1:39 PM
  10. ianmcd replied to the thread Connect 3/4" BSP male cylinder flange to 3/4" BSP male cylinder HW outlet.

    You have an expensive, unvented HW cylinder connected as an open vented cylinder and you want to connect a pump to it ?????? if you have...

    17 Jan 2021 at 1:28 PM